Performance is not the only story, the Impulse cells are constructed in a
way that is more tolerant to 'run away' failures so characteristic of lesser
cells of this type (Li-Po). The Impulse cells use a little more raw material
to achieve this, at no dramatic penalty in terms of weight or size. There
are smaller and lighter cells out there, but none offer this unique
combination of factors that make them ideally suited to our model
requirements
Just look at the pack construction method - The Impulse packs are all
assembled using PCB boards to prevent unwanted 'shorting' that can occur in
packs that just use tape. The security of the connections so close to where
the tabs exit each cell ensures that flexing does not occur, which could
result in the tab breaking. The ends of the pack are then protected using a
small foam pad before a tough heatshrink sleeve is applied. Power cables are
selected to suit the rated out output and securely soldered to the PCB. The
cables are then taped to the pack along its length to prevent flexing at the
joint. There are no plugs installed on the cables to let the buyer choose the plugs that
are best for them. For a list of suggested plugs click on the “other items needed” section.
The balance plug is common to all Impulse packs and is suited to most
of the balance chargers currently in the market. It too is securely soldered
to the PCB.
WARNING! READ ALL INSTRUCTIONS, WARNINGS, AND CAUTIONS BEFORE USE!
DANGER Can cause FIRE! Do NOT short, do not use if HOT or SWOLLEN!
Do NOT charge or leave connected to a charger if unattended.
Do NOT incinerate or use near fire or flame.
Lithium batteries can only be charged with a lithium battery charger.
For a list of recommended chargers see “other items needed” section.
