Radio Control Hobbies and More!


RPM Bumper/Wheelie Bar Mount - Slash/Rustler Black

Be the first to review this product

Availability: In stock

$9.95

No. 719082

RPM Bumper/Wheelie Bar Mount - Slash/Rustler Black

$9.95

Details

RPM Bumper/Wheelie Bar Mount - Slash/Rustler Black After hearing numerous requests to look into the rear bumper mount on the Traxxas Slash, RPM found several issues that could use the RPM touch. Those same problems were encountered on e-Rustler, e-Stampede & Bandit vehicles using the stock wheelie bar mount. The problem the stock mount uses only a single screw on the gear cover side to hold the mount in place. That causes a hinge effect under rear impacts causing the slotted area holding on to the rear skid plate to pop off after an impact, leaving the stock bumper / wheelie bar mount hanging under the chassis. The RPM solution An all-new bumper mounting system that eliminates all of the problems encountered with the stock version.

The RPM rear bumper / wheelie bar mount has two mounting holes on the gear cover side and three on the motor side thats two additional mounting points to eliminate that annoying hinge effect mentioned above. The additional mounting screws help disperse impact energy into the transmission case over more surface area, reducing the possibility of damaging the case significantly! The new RPM mount design means no more slotted parts hanging below the rear skid plate ever! Their mount tucks up quite nicely behind the skid plate for better rear end ground clearance.

This rear bumper / wheelie bar mount fits a wide range of vehicles. It fits all versions of the Traxxas Slash, electric Stampede, electric Rustler and Bandit including VXL, XL-5 and legacy versions.

Tech Notes: The RPM Rear Bumper Mount replaces Traxxas #3677.

Additional Information

SKU 719082
Manufacturer RPM
Mfr Part Number 80902
Video N/A

Product Tags

Add Your Tags:
Use spaces to separate tags. Use single quotes (') for phrases.